(425) 546-2008
Seattle Hot Tube Service

Hot tub repair services in Seattle

Inside the cabinet and in the plumbing, on every brand. Diagnosis first, one written price, parts on the van.

Home›Services

Hot Tub Heater Repair

Heater element, sensor and relay diagnosis for spas that will not reach temperature — plus the soft-water balancing that keeps a new Seattle element from etching through.

Hot Tub Pump Repair

Jet pump and circulation pump repair — seals, wet ends, capacitors, bearings and complete pumps — with every FLO and LF fault traced to its cause rather than its symptom.

Hot Tub Leak Repair

Leak location and repair across the equipment bay and the plumbing: pump seals, unions, heater gaskets, jet bodies, manifolds and glued joints — found with a moisture meter, not a guess.

Hot Tub Control Board & Topside Repair

Balboa, Gecko and brand-specific pack diagnosis — boards, relays, transformers, sensors, topside panels and ribbon cables — repaired or exchanged only after a real test proves the board is the fault.

Hot Tub Jet Repair

Jet inserts, jet bodies, diverter valves, air controls and blowers restored to full pressure — after the flow problem behind weak jets has been found, because it usually is not the jets.

Hot Tub Maintenance & Drain-and-Refill Service

Scheduled drain-and-refill with a plumbing-line flush, filter service, cover and cabinet inspection, and the calcium and alkalinity balance that soft Seattle water needs to stop eating the heater.

Hot Tub Electrical & GFCI Trip Repair

Tripping GFCIs, dead packs and voltage problems traced from the spa disconnect through the pack to each load in turn — heater, pumps, blower, ozone, light — on Seattle's older electrical services.

Hot Tub Winterization & Freeze Protection

Full winterization for tubs that will sit, freeze-damage repair after a cold snap, and the outage plan for the tubs that run through a Seattle winter — because the danger is not the cold, it is the cold during a power outage.

How a visit runs

  1. Tell us the symptomCode on the display, noise, wet spot, no heat. We bring the likely parts.
  2. Diagnosis with a meterWe test before we condemn anything — half of "dead board" calls are a fuse or a plug.
  3. One written priceYou approve it before we start. The diagnostic fee is included in an approved repair.
  4. Repair, balance, noteMost repairs finish the same visit. The water is balanced for Seattle's soft supply and the numbers are written down for you.

Scope, plainly: the spa and what lives inside its skirt. We do not run new circuits, plumb supply lines or set new tubs; we tell you when that is what you need.

Not sure which one you need?

Describe the symptom on the phone and we will tell you.