(425) 546-2008
Seattle Hot Tube Service — Ravenna & Wedgwood, Seattle

Hot Tub Control Board & Topside Repair in Ravenna & Wedgwood

Balboa, Gecko and brand-specific pack diagnosis — boards, relays, transformers, sensors, topside panels and ribbon cables — repaired or exchanged only after a real test proves the board is the fault.

12 min from downtown SeattleZIP 98105, 98115Same-day most daysAll brands
Home›Service areas›Ravenna & Wedgwood›Control Board Repair
Technician at an open hot tub equipment bay, meter on the pump and heater wiring — control board repair in Ravenna & Wedgwood, Seattle
Control Board Repair in Ravenna & Wedgwood: tested before it is quoted.

Why Ravenna & Wedgwood control board repair calls look the way they do

Half the 'dead board' calls in Ravenna & Wedgwood are a fuse, a transformer or a corroded ribbon-cable plug. We test from the breaker inward — transformer output, fuses, sensors, relays — and only then condemn a board, because a board is the most expensive guess in the cabinet.

This is northeast Seattle's larger-lot territory: 1920s brick Tudors in Ravenna and Laurelhurst, mid-century homes with real backyards in Wedgwood, View Ridge and Windermere, and lake access along Sand Point. Older electrical services around Ravenna & Wedgwood let storm surges through, and a board that died the night the power came back is a classic; a surge protector at the disconnect goes in with the replacement.

These are among the best-kept spas on our route — Hot Spring, Caldera, Sundance tubs that owners maintain and call us for when the problem is inside the cabinet. We work Ravenna, Roosevelt, Bryant, Wedgwood, View Ridge and the rest of Ravenna & Wedgwood (98105, 98115).

What Ravenna & Wedgwood owners describe on the phone

Pump or heater runs when it should not

A relay welded closed. Repairable on many boards, replaced on others; we say which before we quote.

Topside blank, nothing lights

Transformer, fuse or ribbon cable before the board. Tested from the breaker in; usually a fuse or a corroded plug.

Error code that will not clear

Sn1, Sn2, SnS, OH, FLO, dr, ICE, HL — each points at a sensor or a flow condition. We read the code in context rather than replacing what it names.

Buttons dead or doing the wrong thing

A worn topside membrane or a ribbon cable — both common after years of wet fingers, both quick to replace.

Ravenna & Wedgwood note. Owner-maintained tubs here usually come with a chemistry log; bring it out, it shortens the diagnosis.

How the visit runs

Scope, plainly: the spa and what lives inside its skirt. New circuits, supply plumbing and setting new tubs go to an electrician or a dealer.

Control Board Repair questions from Ravenna & Wedgwood

My Ravenna & Wedgwood tub died after a storm outage — is the board gone?
Often, but not always. Bigger lots mean longer walks from the panel to the spa and more trees over the cover — Laurelhurst and View Ridge filters load with needles, and the shaded cabinets stay wet from October to April. We check fuses, transformer and sensors first; if the board is the casualty, a surge protector goes in with the new one.
Can the board be repaired instead of replaced?
Relays and some components, yes; burnt traces and water damage, no. We price both for Ravenna & Wedgwood owners so the choice is yours.
Do you handle Hot Spring IQ and Eagle boards?
Yes, along with Balboa, Gecko, Sundance 850 series and Caldera packs. Brand-specific boards are a next-day part when not on the van.
Do you cover Laurelhurst and Windermere?
Yes — both are on the Ravenna and Wedgwood run, about twelve minutes from downtown via NE 45th or 65th.

Control Board Repair near Ravenna & Wedgwood

Control Board Repair in Ravenna & Wedgwood?

98105, 98115 — same-day visits most days. One written price after diagnosis.